Publicité
5 5
Make equal margins along all four edges of the BACKS (I and J). Push on opposite corners of your unit if needed to make it "square".
Fasten the BACKS (I and J) to your unit using the NAILS (HHH).
NOTE: Be sure to tap NAILS into the holes that line up over the BOTTOMS (G2 and H).
Page 10
These edges
should be even.
These holes must line up
over the BOTTOM (H).
J
H
www.sauder.com/services
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
These holes must line up
over the BOTTOM (G2).
I
G2
(29 used in this step)
HHH
NAIL
402375
Publicité
