Publicité
Les langues disponibles
Les langues disponibles
INSTRUCTION SHEET FOR i-PILOT MICRO REMOTE
COMPACT WIRELESS REMOTE TO USE IN ADDITION TO YOUR i-PILOT OR i-PILOT LINK REMOTE
LEARNING THE MICRO REMOTE TO YOUR CONTROLLER
1.
Power up the trolling motor.
2. Push and hold the learn button down.
A steady audio tone will be heard
while holding this button.
3.
While holding the learn button, push
and hold the High Speed Bypass and
AutoPilot keys simultaneously for up to
3 seconds. Three beeps will be heard from
the i-Pilot controller when the remote is
successfully learned.
A remote can be learned to one controller at a time.
A controller can have multiple remotes learned to it.
REMOTE BATTERY REPLACEMENT
1.
Make sure hands are clean, dry and static free. Discharge any static electricity by
touching a metal object that is grounded. *Static electricity can damage the circuit board.
2. With the remote upside down, use a large coin to rotate the battery door counter-
clockwise until either of the Unlock icons align with the arrow (see Figure B).
3.
Remove battery cover and old battery and replace with new CR2450 coin cell
battery. Note the proper polarity of the battery (see Figure A).
4. Ensure the rubber o-ring is properly seated in the underside of the battery cover.
5.
Replace battery cover by aligning either of the Unlock icons with the arrow, pressing
the cover down and rotating clockwise until the Lock icon aligns with the arrow (see Figure C).
ENVIRONMENTAL COMPLIANCE STATEMENT
It is the intention of JOME to be a responsible corporate citizen, operating in compliance with known and
applicable environmental regulations, and a good neighbor in the communities where we make or sell our
products.
WEEE DIRECTIVE:
EU Directive 2002/96/EC "Waste of Electrical and Electronic Equipment Directive (WEEE)" impacts most
distributors, sellers, and manufacturers of consumer electronics in the European Union. The WEEE Direc-
tive requires the producer of consumer electronics to take responsibility for the management of waste from
their products to achieve environmentally responsible disposal during the product life cycle.
WEEE compliance may not be required in your location for electrical & electronic equipment
(EEE), nor may it be required for EEE designed and intended as fixed or temporary installation in
transportation vehicles such as automobiles, aircraft, and boats. In some European Union member
states, these vehicles are considered outside of the scope of the Directive, and EEE for those
applications can be considered excluded from the WEEE Directive requirement.
This symbol (WEEE wheelie bin) on product indicates the product must not be disposed of
with other household refuse. It must be disposed of and collected for recycling and recovery of
waste EEE. Johnson Outdoors Inc. will mark all EEE products in accordance with the WEEE
Directive. It is our goal to comply in the collection, treatment, recovery, and environmentally
sound disposal of those products; however, these requirement do vary within European Union
member states. For more information about where you should dispose of your waste equipment
for recycling and recovery and/ or your European Union member state requirements, please
contact your dealer or distributor from which your product was purchased.
DISPOSAL:
Minn Kota motors are not subject to the disposal regulations EAG-VO (electric devices directive)
that implements the WEEE directive. Nevertheless never dispose of your Minn Kota motor in a
garbage bin but at the proper place of collection of your local town council. Never dispose of
battery in a garbage bin. Comply with the disposal directions of the manufacturer or his
representative and dispose of them at the proper place of collection of your local town council.
FEATURES
High Speed Bypass
"Learn"
Spot-Lock
button
i-Pilot: when engaging Spot-
Lock memory location "A" will
always be used.
i-Pilot Link: when Spot-Lock
is engaged from the Micro
Remote, if you want to save the
location you must go to your
normal Link remote or fishfinder.
Decrease Speed
Steer Left
Figure A
AutoPilot On/Off
i-Pilot: to engage
Advanced AutoPilot, press
the AutoPilot button once.
To engage AutoPilot, press
and hold the AutoPilot
button for two seconds.
Increase Speed
Steer Right
Prop On/Off
Figure B
FCC ID: T62-IPMIC
IC: 4397A-IPMIC
MODEL: MICRO REMOTE
The FCC and IC label can be found
on the back side of the remote.
FCC AND INDUSTRY CANADA
COMPLIANCE STATEMENT:
This device complies with FCC
Rules Part 15 and Industry Canada
RSS-210. Operation is subject to
the following two conditions:
(1) This device may not cause
harmful interference
(2) This device must accept
any interference, including
interference that may cause
undesired operation of the device
Changes or modifications not
expressly approved by the party
responsible for compliance could
PCB
void the user's authority to
operate the equipment. Per FCC
Part 15.21.
BATTERY
RADIO OPERATION:
Remote:
• Frequency band: 2405 MHz to
2480 MHz
• Maximum RF power transmitted:
+8 dBm
Part # 2374971 ECN: 39005 Rev C 03/18
Figure C
Publicité
