Astralpool PRO ELYO INVERBOOST NN 07 Manuel D'installation Et D'utilisation page 36

6.5 Installation of the display deportee
Photo(1)
- The side with plug connects with the control panel (photo1)
- The other side of the signal wire. (photo2)
- Open the wiring panel and put the side without plug through the electrical box. (photo3,4)
- Insert the wiring into the designated position on the Modbus Module or PCB(without Modbus). (photo5)
6.6 Installation of the Modbus/Fluidra Connect Signal Wire
Photo(6)
- Open the terminal cover (photo6)
- Take the Modbus/Fluidra Connect signal wire from the accessories
wire into the signal wire from Modbus/Fluidra Connect Module. (photo 8)
- Three wire terminal :"A+" ,"B- ", "GND" (Photo 9)
6. 6. 6. Electrical Electrical Electrical
Photo(2) Photo(3)
Photo(7)
Wiring Wiring Wiring
Photo(4)
Photo(8)
( ) and
photo7
- 32 -
Photo(5)
Photo(9)
put the round end of the signal