Electrical Connection - Astralpool PRO ELYO INVERBOOST NN 07 Manuel D'installation Et D'utilisation

6.4 Electrical connection

The power supply for the heat pump must come, preferably, from an exclusive circuit with regulatory protection
components (30mA differential protection) and a magneto-thermal switch.
- The electrical installation must be carried out by a specialized professional (electrician) in accordance with the
standards and regulations in force in the country of installation.
- The heat pump circuit must be connected to a safety earth circuit at the terminal block.
- The cables must be properly installed to prevent interference.
- The pump is intended for connection to a general power supply with earth connection.
- Section of the cable; This section is indicative and should be checked and adapted according to the needs and
conditions of use.
- The tolerance of acceptable voltage variation is +/- 10% during operation.
The connections must be dimensioned according to the power of the device and the state of
installation.
Models
PRO ELYO INVERBOOST NN 07
PRO ELYO INVERBOOST NN 10
PRO ELYO INVERBOOST NN 14
PRO ELYO INVERBOOST NN 17
PRO ELYO INVERBOOST NN 21
PRO ELYO INVERBOOST NN 26
PRO ELYO INVERBOOST NN 26T
PRO ELYO INVERBOOST NN 35
PRO ELYO INVERBOOST NN 35T
These values are given as a guideline, only the intervention of an authorized technician can determine
the values corresponding to your installation.
The electric line must be equipped with a ground connection and with a circuit breaker with difference
30mA in head.
6. 6. 6. Electrical Electrical Electrical Wiring Wiring Wiring
Circuit
breaker
2,5 mm²
7 A 84 m
10 A 57 m
13 A 43 m
16 A 34 m
20 A 29 m
26 A 135 m
9 A 105 m
34 A 21 m
13 A -
- 31 -
Maximum length of the wire
4 mm² 6 mm²
135 m 200 m
90 m 130 m
68 m 100 m
54 m 80 m
45 m 66 m
210 m 315 m
160 m 240 m
34 m 49 m
27 m 39 m
10 mm²
335 m
225 m
170 m
135 m
110 m
525 m
400 m
84 m
68 m