Human Touch Perfect Chair pc610 Manuel D'utilisation Et D'entretien page 4

get ready
UNPACK THE BOXES
Backrest frame
Chair frame
Arm core
Head sock 3/16-inch
Screw (4) Allen wrench
ATTACH THE BACKREST FRAME
1. Remove the backrest frame screws.
Using the provided Phillips-head screwdriver,
remove the two screws/washers from the two
lower ends of the backrest frame. Save these
screws/washers as they will be used later in the
assembly process.
humantouch.com
All manuals and user guides at all-guides.com
Arm cap (2)
Screw (6) Phillips-head
Body pad
screwdriver
Head pad Head pillow
Backrest frame
Screw
Washer
4
Your Human Touch Perfect Chair
®
attach the backrest frame, pads, arm caps, and head pillow, and you're done!
2. Insert the backrest frame into the chair base.
With the backrest frame positioned so that the headrest can
tilt forward, slide the two ends of the backrest frame into the
open tube ends of the chair base.
3. Install the canvas backrest support.
Pull the chair canvas firmly upward as far as it will go, wrap the
top flap around the backrest frame and secure it using the hook-
and-loop fasteners. It is important that the canvas be stretched
tight to provide proper back support.
4. Replace the backrest frame screws.
Using the Phillips-head screwdriver, install the two screws with
washers (previously removed from the backrest frame) to secure
the backrest frame and glide rail safety tip.
WARNING:
You must install these two screws before using the chair; failure to do so may cause severe injury.
ATTACH THE BODY PAD
1. Slide the body pad onto the chair frame.
Slide the body pad onto the lower part of the chair frame,
making sure that the frame slides into the fabric pocket located
on the bottom side of the pad.
2. Secure the body pad.
Smooth the body pad into place, from the footrest toward the
backrest. The pad is automatically secured using the hook
and loop fasteners.
requires some simple assembly. Just
®
Top flap
Canvas
Backrest frame
Glide rail safety tips
5 5