L.
Wheel Charger Assembly Instructions:
NOTE: Charger must be assembled before operating.
Parts
Tools necessary
(2) 10-32 screws
5/16" wrench
(2) 1/4-20 screws
3/8" wrench
(2) wheels
Hammer
(2) axle caps
Screwdriver
(2) axle brackets
(1) handle
(1) mounting foot
(1) axle
First place the charger on it side.
Next mount the mounting foot FIG. A with (2) 1/4-20 screws.
Next pound the axle firmly into an axle cap using a hammer FIG. B.
Next slide the wheels onto the axle, hubs must face in, FIG. C.
Next pound the other axle cap onto the other end of the axle.
Next place the axle assembly onto the bottom of the charger as shown in FIG. C.
Mount the axle to the bottom of the charger using (2) 10-32 screws as shown in FIG. D.
Next turn the charger right side up onto its foot and wheels.
Remove the (2) top screws from each side of the charger, line up the handle and reinstall the screws FIG. E.
M.
If a problem does occur, check the following:
PROBLEM
No Meter Reading.
(AC Cord Unplugged)
Charger will not turn on when
properly connected.
Clicking noise from charger.
ASSEMBLY INSTRUCTIONS
HUBS MUST
Fig. A
TROUBLESHOOTING
POSSIBLE CAUSE
Clips are not making a good
connection.
Battery voltage is too low.
2 amp charge rate being used.
AC outlet is dead.
Poor electrical connection.
Circuit breaker is cycling.
Battery is defective.
Severely discharged battery but
otherwise a good battery.
Reverse connections at battery.
6
FACE IN
Fig. C
AXLE BRACKET
Fig. D
SOLUTION
Rock clips back and forth for a better
connection.
Plug AC line into outlet. Meter should now
indicate.
None, meter will not indicate here.
Plug in a lamp to check for voltage.
Check connections, rock back and forth for a
better connection.
May be in the wrong switch position.
Have Battery checked.
Allow charging to continue until battery has a
chance to recover sufficiently to take a charge.
If more than 20 minutes stop charging and
have the battery checked.
Shut off charger and correct lead connections.
Fig. B
AXLE CAP
Fig. E