Installation Instructions - MAAX Olio 107140 Guide D'installation

Installation Instructions

12 12
Measure the distance between the top of the back horizontal flange and the bottom of the pan
ledge, approximately 1 1/2" (40mm). Mark this dimension on the back studs, below
the rst mark.
14 14
Install drain assembly per manufacturer's instructions.
16 16
Tap down until level. Level horizontally and vertically using a level. Use
shims if necessary. The apron should be resting firmly on the ground.
Customer Service: 1-877-GET-MAAX (1-877-438-6229).
— 5 —
Installation steps
13 13
Fasten a 1" x 3" (25mm x 75mm) ledger strip along rear of alcove and
along both sides (immidiately below the lower marks made on framing).
15 15
Place base into framing pocket.
17 17
Pre-drill horizontal and vertical flanges and fasten into each corresponding stud.
6030 WALL SET