Suntec Wellness KLIMATRONIC ADVANCE 9.0 Eco R290 APP Mode D'emploi page 18

2.1 Cooling Mode
- Please select the cooling mode to lower the temperature in your room
- Please press the MODE button repeatedly until the "Cool" indicator lights up.
- Press the up/down button to set the temperature. The temperature can be set between 16℃ and 30℃.
- Please press the fan speed button repeatedly until the desired indicator lights up.
Please press the oscillation button on the remote control in order to activate or deactivate the automatic
vertical movements of the fins.
NOTE: The air conditioner stops when the room temperature is below the set temperature.
2.2 Fan Mode
- Please press the MODE key repeatedly until the "Fan" indicator lights up.
In ventilation mode, the room air is circulated but not cooled.
- Please press the SPEED button to select high, medium or low speed.
2.3 Dehumidification Mode
- Press the MODE button on the control panel or remote control until the "Dry" indicator lights up. The
fan speed cannot be selected. The user should connect the drainage hose to the drain at the bottom of
the unit.
Note: In this mode, the fan speed switches to Low and cannot be set.
2.4 Oscillation
Please press the oscillation button on the remote control in order to activate or deactivate the automatic
vertical movements of the fins.
2.5 Heating Mode
- Please press the MODE button repeatedly until the "Heat" indicator lights up.
- Press the up/down button to set the temperature. The temperature can be set between 16℃ and 30℃.
- Please press the fan speed button repeatedly until the desired indicator lights up.
Please press the oscillation button on the remote control in order to activate or deactivate the automatic
vertical movements of the fins.
3. TIMER 1h-24h:
When the unit is switched on, press the TIMER button first. Now you can set the desired switch-off time
with the up/down buttons.
When the unit is switched off, press the TIMER key to set the switch-on time.
4. Automatic Frost Protection:
At low room temperatures, frost may accumulate on the evaporator during operation. In this case, the
unit automatically starts defrosting and the POWER LED flashes. The defrost control sequence is as
follows:
- When the unit is operating in cooling mode or dehumidification mode, the ambient temperature sensor
detects the evaporator coil temperature. As soon as this drops below -1°C, the compressor is switched
off. After the compressor has stopped operating for 10 minutes or reaches the coil temperature 7℃, the
unit restarts in cooling mode.
5. Overload Protection:
In the event of a power failure, there is a 3-minute delay until the compressor restarts to protect the
compressor.
6. Sleep mode:
Please press the timer button (8) and the up button (5) at the same time to switch on the sleep mode.
This mode can only be set when the unit is in cooling mode. The unit will operate at low fan speed and
the selected temperature. After 2 hours, the unit will automatically increase the temperature by one
degree, and again by one degree after another 2 hours. To end the sleep mode, please confirm the timer
key (8) and the up key (5) at the same time.
Connection to the Wifi and the Suntec Wellness APP
• Please download the "SUNTEC Wellness" app from the App Store or Google Play and install it.
• Please create a user account after the installation.
• Please activate the Bluetooth access in the settings of your mobile device.
• Please connect the device to the power and press and hold the On/Off button (1) until you hear a beep
and the "WiFi" indicator (9) flashes slowly. Please press and hold the On/Off button (1) again until you
hear a signal tone.