Intellinet Network Solutions IPII-84G Instructions page 3

1 Using Cat5e/6/6a/8.x Ethernet cable, connect a LAN port on
your non-PoE switch to the DATA port on the injector.
2 Using Cat5e/6/6a/8.x Ethernet cable, connect your powered device
(IEEE 802.3af/at/bt compliant) to the PoE OUT port on the injector.
A — LEDs
Placement
Desktop Installation
Prior to use, place/position the device:
• on a level surface that can support its weight;
• with at least 25 mm (approx. 1") of clearance for ventilation;
• away from sources of electrical noise: radios,
transmitters, broadband amplifiers, etc.;
• within 100 m (approx. 328') of network devices it's to be connected to.
DIN-Rail Installation
1 Angle spring of mounting clip over top lip of DIN rail.
2 Push device down till clip clicks onto rail.
3 Ensure installation is stable.
LED
PWR
Injector is powered on.
PoE
Injector is delivering power.
2
1
Status
Instructions
3
English 3