Télécharger Imprimer la page

Alto SQ 550-21 Mode D'emploi page 50

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 52
Push on a new filter
element.
Fit the filter retaining
washer and tighten the
retaining nut.
Dispose of the used
filter element in
accordance with the
local waste disposal
regulations.
TROUBLESHOOTING
‡ Motor does not start
‡ Reduced suction
power
‡ No suction power
during wet cleaning
Option/model variant
1)
8
Bedienungsanleitungen auf www.gluesing.net
TESTS AND APPROVALS
Electrotechnically tested
according to test
methods/principles:
DIN VDE 0700 Part 1
(= DIN 60335-1)
DIN VDE 0700 Teil 205
DIN EN 60335-2-69.
As a result of these tests,
suitable for higher load
for commercial
application.
Problem
> Fuse of mains plug
socket has blown
> Overload protection
switch has tripped
> Bag-type filter full
> Suction hose clogged
> Filter element clogged
> Tank full (float switch
closing off the suction
opening)
Electrotechnical tests must
be performed in
accordance with the
provisions of the Accident
Prevention Regulations
(VBG4) and to DIN VDE
0701 Part 1 and Part 3. In
accordance with DIN VDE
0702, these tests must be
performed at regular
intervals and after repair
or modification.
Cause
Reset the fuse
Allow the cleaner to
cool down for approx.
5 minutes; if the
cleaner does not start
again automatically,
contact the Service
Dept.
Replace bag-type filter
Clean suction hose
Clean or replace filter
element
Empty tank
Remedy

Publicité

loading