Télécharger Imprimer la page

Alto SQ 550-21 Mode D'emploi page 49

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 52
PICKING UP DRY
SUBSTANCES
Before picking up dry
substances, the bag-type
filter should always be
installed in the tank. It is
then easy to dispose of
the material picked up
and the service life of the
main filter element is
significantly increased. Dry
cleaning without bag-type
filter is also possible.
Inflammable substances
must not be picked up
with the cleaner!
After picking up liquids,
the filter element is damp.
Damp filter elements can
clog more quickly when
dry substances are picked
up. For this reason, the
filter element should be
dried or replaced by a dry
element before picking up
dry substances.
PICKING UP LIQUIDS
Before picking up liquids,
the bag-type filter must
always be removed from
the tank.
Inflammable liquids
must not be picked up
with the cleaner!
If foaming is observed,
stop work immediately
and empty the tank.
Option/model variant
1)
Bedienungsanleitungen auf www.gluesing.net
SWITCHING ON THE
CLEANER
SQ 450/550/650-11:
Turn the switch to
position 'I' (Fig. 5).
SQ 450-21/-31
and SQ 550/650-31:
Two operating modes are
possible:
Switch position 'I':
The cleaner motor starts
immediately.
Switch position 'auto':
The cleaner motor starts
only when the tool
connected to the
appliance plug socket is
switched on (Fig. 6).
CAUTION!
Before turning the
switch to position
'auto', ensure that the
tool connected to the
appliance plug socket is
switched off.
The motor speed and thus
the suction power can be
varied at the suction force
regulator
1)
. This permits a
precise adaptation to
different substances to be
picked up (Fig. 6).
AFTER FINISHING WORK
Switch off the cleaner
and pull the plug of
the mains lead out of
the plug socket.
Wind up the mains
lead (Fig. 7).
CHANGING THE BAG-
TYPE FILTER
Close the bag-type
filter sleeve with the
slide (Fig. 8).
Pull the bag-type filter
sleeve off the inlet
fitting.
Dispose of the used
bag-type filter in
accordance with the
local waste disposal
regulations.
Place a new bag-type
filter into the tank as
described in the
instructions (printed
on the filter).
IMPORTANT!
Push the bag-type
filter sleeve completely
onto the inlet fitting.
REPLACING THE FILTER
ELEMENT
Switch off the cleaner
and pull the plug of
the mains lead out of
the plug socket.
Remove the cleaner
top section from the
dirt tank and place to
one side with the filter
element facing
upwards (Fig. 9).
Unscrew the filter
retaining nut (1) and
remove together with
the retaining washer
(2).
Pull off the filter
element (3).
7

Publicité

loading