Allen + Roth 1315VA-48-201 Instructions De Montage page 4

VANITY INSTALLATION INSTRUCTIONS
2. To remove drawers preassembled in vanity (A).
Fully extend drawers, locate plastic levers on
metal glide tracks at left and right sides of
drawer box, push on plastic levers on both
sides at the same time, to disengage drawer
box from the glides, Then gently lift the drawer
up to remove it from vanity (A).
2026VA-36-200
3. Clean area where the vanity (A) will be
permanently located prior to beginning
installation, ensuring the vanity (A) will not
interfere with any water supply and drain lines
once mounted.
Locate wall studs and mark locations.
Using hardware appropriate for your wall
1227WC
type (not included), secure the Wall Bracket
(H) to the wall into preferably 2 wall studs. Use
hardware such as a cabinet screw or toggle bolt
depending on your wall type. Make sure the
Wall Bracket (H) is level and centered well to the
desired location of the Vanity (A). Be careful
not to disturb any plumbing or electrical lines that
may be concealed in the wall.
!IMPORTANT SAFTEY STEP!
It is critical to have a strong secure
connection to the wall before continuing to
the next step.
All manuals and user guides at all-guides.com
4
2
A
3
H
1
2