Publicité
Les langues disponibles
Les langues disponibles
the plug replaced with a suitable model by a qualified professional,
who should ensure that the cord is suitable for the power rating of the
appliance (10A). Check that other appliances with high absorption are
not connected to the power line to avoid overloading and fire hazards.
The use of adaptors or extensions is generally not advisable; if it is
necessary to use them, they must comply with safety regulations and
the total current (amps) must not be rated lower than the maximum
current of the appliance.
• Before each use, check that the appliance is in good condition and that
the power cord is not damaged: if in doubt consult a qualified
professional.
• Ensure that the power cord is correctly positioned and does not come
into contact with hot parts or sharp edges, or become wound around
the appliance itself and is not twisted.
• Do not hang or even lean the appliance against any walls.
• Place the fan heater far from any other source of heat, from flammable
material (curtains, tapestries, etc.), from flammable gases or explosive
objects (spray cans) and from materials that can be deformed by heat.
Make sure there is 120 cm of free space in front of the fan heater and
50cm free space on both sides and behind it.
• The surface where the appliance is used must be stable, spacious (do
not use on shelves or steps), level (since the appliance could tip over)
and heat resistant.
USING THE APPLIANCE
First use
Warning: run the appliance to eliminate the "new smell" and any oil
residue from the manufacturing process for at least 10/15 minutes.
During this operation, ventilate the room well to eliminate the "new
smell" that is given off by the appliance.
The heating fan can be adjusted using the following:
-Selector (3). By turning the relative knob clockwise, you can select these
functions:
hot air (1800 W).
-Room thermostat (1). It adjusts the appliance's functions according to
the temperature, continuously until reaching the set temperature, then
at intervals to keep it constant. By turning the relative knob completely
anti-clockwise the heating fan remains off (pos."-"), when turned
completely clockwise it is set on the maximum temperature (pos."+"), in
intermediate positions the surrounding temperature is lower.
- Indicator light: comes on according to the thermostat's operation. It is
on when the appliance is running.
0= off,
only ventilation, I= hot air (900W) I I= very
16
Publicité
