JVC AV-27GFH Manuel D'instructions page 10

Step Two - Making Basic Connections
Next you will need to connect your television to an antenna or cable system. The most basic
antenna/cable connection is shown below. For more detailed connections, such as ones where a
cable box is required, see pages 11 to 13.
AUDIO VIDEO
R L MONO
DIGITAL
INTERFACE
1) Connect an RF cable out from the wall outlet in to the RF Input on the back of the TV.
You may also wish to connect a VCR at this point. A basic VCR connection is shown below.
Note: A VCR is not required to operate your television.
AUDIO VIDEO S-VIDEO
R L MONO
REAR
IN
OVER
DIGITAL
INTERFACE
1) Connect the yellow video cable out from the VCR's Video Output, in to the TV's Video Input
jack, OR connect an S-Video cable from the VCR's S-Video Output, to the TV's S-Video Input.
2) Connect the white audio cable out from the VCR's Left Audio Output, in to the TV's Left Audio
Input jack.
3) Connect the red audio cable out from the VCR's Right Audio Output, in to the TV's Right
Audio Input jack.
Finally, once you have finished your connections, plug the power cord into the nearest power outlet
and turn on the television.
10
Quick Setup 2
AUDIO VIDEO
R L MONO
DIGITAL
INTERFACE
S-VIDEO
REAR
IN
OVER
AUDIO VIDEO
S-VIDEO
R L MONO
OVER
DIGITAL
INTERFACE
OR
STOP
CABLE or ANTENNA
S-VIDEO
REAR
IN
OVER
REAR
IN
The Quick Setup
is complete
OUT
Cable/RF connector
AV Cables/Plugs
IN
OR
VCR