Important - Bestway 56432 Mode D'emploi

SPLASH-IN-SHADE
PLAY POOL
OWNER'S MANUAL
Product Description
Item No.
Dimension
#56432 2.44m x 51cm (8' x 20'')
Installation usually takes approximately 20 minutes with 2-3 people
excluding earthworks and filling.
WARNING
Carefully read, understand, and follow all information in this user manual before installing and using the swimming
pool. These warnings, instructions, and safety guidelines address some common risks of water recreation, but they
cannot cover all risks and dangers in all cases. Always use caution, common sense, and good judgment when
enjoying any water activity. Retain this information for future use.
Non Swimmers safety
- Continuous, active, and vigilant supervision of weak swimmers and non-swimmers by a competent adult is required
at all times (remembering that children under five are at the highest risk of drowning).
- Designate a competent adult to supervise the pool each time it is being used.
- Weak swimmers or non-swimmers should wear personal protection equipment when using the pool.
- When the pool is not in use, or unsupervised, remove all toys from the swimming pool and its surrounding to avoid
attracting children to the pool.
Safety devices
- In order to prevent children from drowning, it is recommended to secure the access to the pool with a protection
device. In order to prevent children climbing from the inlet and outlet valve, it is recommended to install a barrier (and
secure all doors and windows, where applicable) to prevent unauthorized access to the swimming pool.
- Barriers, pool covers, pool alarms, or similar safety devices are helpful aids, but they are not substitutes for
continuous and competent adult supervision.
Safety equipment
- It is recommended to keep rescue equipment (e.g. a ring buoy) by the pool.
- Keep a working phone and a list of emergency phone numbers near the pool.
Safe use of the pool
- Encourage all users especially children to learn how to swim
- Learn Basic Life Support (Cardiopulmonary Resuscitation - CPR) and refresh this knowledge regularly. This can
make a life-saving difference in the event of an emergency.
- Instruct all pool users, including children, what to do in case of an emergency
- Never dive into any shallow body of water. This can lead to serious injury or death.
- Do not use the swimming pool when using alcohol or medication that may impair your ability to safely use the pool.
- When pool covers are used, remove them completely from the water surface before entering the pool.
- Protect pool occupants from water related illnesses by keeping the pool water treated and practicing good hygiene.
Consult the water treatment guidelines in the user's manual.
- Store chemicals (e.g. water treatment, cleaning or disinfection products) out of the reach of children.
- Use the signage as outlined below. Signage is to be displayed in a prominent position within 2m of the pool.
Keep children under supervision in the aquatic environment. No diving.
- Removable ladders shall be placed on a horizontal surface.
- Irrespective of materials used for swimming pool construction, accessible surfaces have to be checked regularly to
avoid injuries.
- Regularly monitor bolts and screws. Remove splinters or any sharp edges to avoid injuries.
ATTENTION: Do not leave the drained pool outside. The empty pool is liable to become deformed and/or displaced
due to wind.
- If you have a filter pump, refer to the pump's manual for instructions.
WARNING! The pump cannot be used while people are inside the pool!
- If you have a ladder, refer to the ladder's manual for instructions.
WARNING! The use of a swimming pool implies compliance with the safety instructions described in the operating
and maintenance guide. In order to prevent drowning or other serious injuries, pay particular attention to the
possibility of unexpected access to the swimming pool by children under 5 years by securing the access to it, and,
during the bathing period, keep them under constant adult supervision.
Please read carefully and keep for future reference
Components list
A
E
I
Underwater adhesive repair
patch
Kit Type Accessories
Aboveground swimming pool kit Sun Shade
B C
F G
J K
M N
Ref# Description
A Top Rail
B Vertical Pool Leg
C T-Connector
D Pin
E Footing
F+M+N Sprayer + Hose + Adaptor
G Drain Valve
H Hose Adaptor
Note: Drawings not scaled to size.
Please see FAQ'S for additional information.
CHOOSE THE CORRECT LOCATION
IMPORTANT: The pool must be set up on a completely flat and level surface. Please do not install the pool if the surface is Inclined or
sloped.
Correct conditions to set up the pool:
• The selected location has to be capable of uniformly supporting the weight for the entire time the pool is installed, moreover the
location must be flat and must be cleared of all objects and debris including stones and twigs.
• We recommend positioning the pool away from any objects kids could use to climb into the pool.
NOTE: Position the pool near an adequate drainage system to deal with overflow or to discharge the pool.
NOTE: Position the pool near an AC power outlet protected by a RCD (Residual Current Device).
Incorrect conditions to set up the pool:
• On uneven ground the pool may collapse causing serious personal injury and/or damage to personal property and will void the
warranty and prevent any service claims.
• Sand should not be used to create a level base; the ground must be dug out if necessary.
• Directly under overhead power lines or trees. Be sure the location does not contain underground utility pipes, lines or cables of any
kind.
• Do not set up the pool on driveways, decks, platforms, gravel or asphalt surfaces. The selected location should be firm enough to
withstand the pressure of the water; mud, sand, soft / loose soil or tar are not suitable.
• Grass or other vegetation under the pool will die and may cause odors and slime to develop, therefore we recommend removing all
grass from the selected pool location.
• Avoid areas prone to aggressive plant and weed species that may grow through the ground cloth or liner.
NOTE: Check with your local city council for by-laws relating to fencing, barriers, lighting and safety requirements and ensure you
comply with all laws.
NOTE: If have a filter pump, refer to the pump's manual for instructions.
NOTE: The ladder must match the pool size and should to be used only for entering and exiting the pool. It is forbidden to exceed
the permitted payload of the ladder. Check regularly if the ladder is properly assembled.
Fig. 1
Fig. 4
Fig. 7
Fig. 10
Assembly the Splash-in-Shade play pool no need any tools.
Bestway Inflatables will not be responsible for damage caused to the pool due to mishandling or failure to follow these instructions.
1. Lay out all parts and check that you have the correct quantities as listed in the components list. If you are missing any part do not
assemble the pool, contact Bestway Customers Service.
2. Spread out the pool and make sure the pool is right side up, let it sit exposed to direct sunlight for 1 hour or more so that the pool
is more flexible during set up.
3. Turn the pool so the drain valve is near the area where your plan to drain the water.
ATTENTION: Do not drag the pool on the ground in order to avoid puncturing from sharp objects.
4. Insert the stopper plug into the inlet and outlet on the wall of the pool from the inside of the pool. (See Fig. 8)
5. Insert top rail (A) into the pole pockets at the top of the pool. (See Fig. 1)
6. Connect top rail (A) with T-Connector (C) at each of corner and insert pins (D) into pre-drilled holes of the frame. (See Fig. 2, 3)
7. Repeat steps 5 and 6 until all top rails (A) are connected with all T-Connectors (C) and the top frame is set up.
NOTE: For ease of assembly slightly raise the last 2 rails to an inverted v shape and insert into the last T-Connectors(C). Slowly
lower until fully connected taking care not to pinch your fingers. (See Fig. 4)
8. Connect vertical pool leg (B) into the bottom of the T-Connector (C). (See Fig. 5)
D
NOTE: Make sure the hole on the vertical pool leg (B) is facing outward.
9. Attach all footings (E) to the bottom of the vertical pool legs (B). (See Fig. 6)
10. When the pool is completely assembled pull the frame from different directions to ensure all rails, pool legs and connectors are
firmly jointed. (See Fig. 7)
11. Ensure drain valve is firmly closed. Smooth out the bottom.
12. Insert the 8 Tent legs (K) to the 8 T-Connectors (C) (See Fig. 9)
13. One fiberglass pole (L) has 3 sections. Extend the fiberglass pole by pulling out each section and place it into the metal ferrules.
14. Insert one end of the pre-extend fiberglass pole to the Tent leg (K), the other end to the Sprayer (F). Repeat this step for the other
H
fiberglass poles. Make sure the 8 fiberglass poles form a semidome. (See Fig. 10)
15. Spread the tent's outer cloth (O), make sure the center is above on the Sprayer (F), adjust the tent's outer cloth (O) position until
the sewing lines are superposed to the fiberglass poles (L). Hook the tent's outer cloth (O) to the hole of the vertical pool leg
(B).(See Fig. 11)
16. Tie the outer cloth (O) to the fiberglass pole (L) by using the 3 pairs ropes at the inner of outer cloth (O). The rope can also fix the
hose (M).
17. Smooth out all wrinkles on the outer cloth and make it perfect.
IMPORTANT: Put 1" to 2" water in the pool to cover the floor. Once pool floor is slightly covered, gently smooth out all wrinkles.
L
Start in the center of the pool and work your way clockwise to the outside.
Filling Pool with Water
ATTENTION: Do not leave pool unattended while filling with water
NOTE: The Hose Adapter can be used with two different garden hoses.
1. Fill pool until water capacity is 90%, DO NOT OVERFILL as this could cause the pool to collapse. In times of heavy rainfall you
may need to empty some of the water to ensure the level is correct. (See Fig. 12.13)
2. When filling the pool is completed, check that the water is not collecting on any side to ensure the pool is level.
O
IMPORTANT: If pool is not level, drain water and re-level ground by digging out (See Fig. 14). Never attempt to move the pool with
water in it, serious personal injury or damage to the pool may result.
WARNING: Your pool may contain up to xxxxx liters/xxxx gallons which equals xxxxx pounds of pressure. If your pool has any
bulge or uneven side then the pool is not level, the sides may burst and the water may discharge suddenly causing serious
personal injury and/or damage to property.
5
Quantity Ref# Description
8 I Stopper plug
8 J Liner
8 K Tent leg
18 L Fiberglass pole
8 O Tent's outer cloth
1
1
1
Fig. 2 Fig. 3
Fig. 5 Fig. 6
Fig. 8 Fig. 9
Fig. 11
Quantity
2
1
8
8
1
S-S-005933