Beha-Amprobe UAT-600-EUR Guide Rapide page 12

UAT-600-EUR Underground Utility Locator Series
Signal Clamp
Tracing an Individual Pipe or Cable
Setting up the Transmitter
1. Turn the Transmitter on by pressing the
power button for two seconds.
2. Connect the black and red test leads of
the Signal Clamp to the Transmitter inputs.
The Transmitter will switch automatically to
the Clamp Mode and the display will show
the clamp icon.
3. Clamp the Signal Clamp around the
target line.
10
4. Press "Hz" repeatedly to select 8 kHz
frequency (preferred for most tracing situations)
or 33 kHz.
5. Press
Increase the level if the resulting signal strength
is poor. Increasing the signal unnecessarily may
result in the signal "bleeding off" onto other
services and creating misleading "ghost" signals.
500
to set the output to level one.