Stahl 8150/1 Serie Mode D'emploi page 13

 Modify the device carefully and only in accordance with the safety information
(see "Safety" chapter).
 Calculate the usable area for built-in components.
 Create additional drilled holes through lasing or punching (drilling, hole cutting).
When doing so, maintain a distance of min. 10 mm / 0.39 inches to the rim of the enclosure
(see figure).
All dimensions in mm [inches]
10 [0,39]
 When punching and cutting, make sure that the outer surfaces of the enclosure
remain flat and undamaged (without cracks).
 Observe the mounting distances when creating the drilled holes.
 Adjust the hole diameters to the dimensions of the built-in parts or their seals.
 ONLY use built-in components with flat seal (gasket).
 Observe chapter 5.2 when subsequently equipping components!
 If the technical data has changed, e.g. due to the components that are to be additionally
installed, attach the new rating plate with the current values.
212727 / 815060300170
2021-02-25·IO00·III·en·02
Product Selection, Project Engineering and Modification
Terminal boxes
Series 8150/1, Series 8150/2
US
US
US
US
US
US
US
US
US
US
US
US
US
18105E00
US
US
US
US
US
US
US
US
US
US
US
US
13