Publicité
PKCP75XX
headstock
Turning The Blanks
• Mount the bushings and blank according to Diagram B.
• Thread on the knurled nut and hand tighten to hold all components in place.
• S lide the tailstock up snugly against the mandrel shaft inserting the live center point into the mandrel dimple, lock in place.
• H and tighten the quill adjustment to firm up the mandrel. (DO NOT overtighten, it could damage the mandrel.
• U sing sharp tools, turn the blank down close to the bushing diameter. Turn the barrel (straight or to a profile of your choice)
• Sand the blank down to be flush with the bushings gradually increasing the sandpaper grits.
• F inish the barrel with your choice of polish. Allow sufficient time for the polish to cure. - refer to polish instructions.
Assembly
• Position the bolt either in Position A or Position B. (Delivered in position A)
• Position A - Check to see if bolt is tightly in place. To tighten see Note 1
• Position B - Reverse the direction of the bolt. See Note 1 on loosening / tightening the bolt.
• Rotate the clip to slot B (press into slot)- do this by Unscrewing the Cap and rotating the clip.
• Re- attach the cap after re-positioned
NOTE: Layout Finished parts according to Diagram A
• Press the threaded nut into either end of the barrel.
• Press the back end assembly into the opposite end of the barrel.
• Insert the spring over the refill.
• Place the bolt in an off position, insert the refill back end in first into the opening
NOTE: Please do not press the front end of this kit with the tip removed.
If you do so the parts will not assemble properly and you will void our
warranty
DIAGRAM D - Bushings
#PKCP7000BU
ø.525"
ø.356"
DIAGRAM B - Turning the Blanks
Blank
7mm spacer
bushings
barrel
End
wood
bushing
ø.525"
ø.356"
ø.248" hole through
© 2013 PSI Woodworking Philadelphia PA 19115 - v4/13
knurled nut
mandrel
7mm spacer
End
bushings
bushing
PSI Woodworking Products
live
center
NOTE1:
To loosen or tighten the bolt,
loosen or tighten the set screw as
shown below in diagram C. Take
a long phillips screw driver with a
small head, insert into the back end
as shown. Rotate the bolt as neces-
sary and tighten the set screw.
DIAGRAM C
Back End
Set Screw
Bolt Position B
Bolt Position A
Publicité
