Setting Up The Receiver - Amplicomms TV 2400-1 Mise En Service

Your TV 2xxx-1 / TV 2xxxNL-1 is an additional receiver for your TV 2400
/ TV 2500 / TV 2410NL / TV 2510NL. After having inserted and charged
the battery you will have to register it to the transmitter. There is no
limit number of receivers to be registered to the TV 2400 / TV 2500 / TV
2410NL / TV 2510NL transmitter for use together.
For more information about the operation and hints on safety and dis-
posal, please refer to the manual of your TV 2400 / TV 2500 / TV
2410NL / TV 2510NL.

Setting up the receiver

Inserting and charging the rechargeable battery
1 Insert a battery into the headset receiver.
2 Charge the battery before first use. Switch off the receiver (position OFF).
Place the receiver into the charging cradle of the transmitter. The char-
ging process starts automatically. The battery LED indicator will be red
and will turn to green when the battery is fully charged. This takes about
2 hours and 30 minutes.
Alternatively you can use the fully charged spare battery from the trans-
mitter.
Registering the receiver
1 Turn off the transmitter if it is on (disconnect from the mains).
2 Disconnect the audio source input.
3 Turn on the NEW headset, the LED indicator will be flashing on and off
slowly.
4 Press the MIC button and hold for 3s, the green LED indicator will flash
on and off quickly.
5 Turn on the transmitter immediately (must be done within 9s, or need to
redo step 4).
6 If the registration is successful, you will hear a short confirmation tone in
the headset and the green light on the headset will automatically stop
flashing and will light constantly. This indicates that registration was suc-
cessful.
7 Reconnect the audio source input.
(See user manual TV 2400/TV 2500/TV 2410NL/TV 2510NL for costs and hours of operation)
TV 2
Helpline UK 0844 800 6503
-1 / TV 2
XXX
NL-1
XXX