Witter TY158AU-FIT Instructions De Montage

Fitting
Instructions
MATERIALS
A 1 Crossbar
D 6 M12 x 35 x 1.25 Bolts and Flat Washers (25mm O.D.)
E 1 M6x 20 x 1.00 Bolt and Flat Washer
ZE 1 Flip up Electrical plate kit (Z99)
Z 1 Angle Plate (ZEP5)
FITTING
1. Remove lower under tray and exhaust heat shield. (Petrol models only- lower rear silencer )
Remove lashing eye bolted to left hand chassis rail.
2.
Loosely attach Cross bar (A) to vehicle chassis using Bolts (D). Fully tighten Bolts.
3.
Refit exhaust heat shield (use longer bolt (E). Re-secure rear silencer .
4.
Attach neck option and Flip up electrical plate (Z) (ZE).
5.
Cut under tray as shown below and refit.
6.
Recommended torque settings: Grade 8.8 bolts: M8 - 24Nm, M10 - 52 Nm, M12 - 80 Nm, M14 - 130 Nm, M16 - 200
Nm Grade 10.9: M12 – 120Nm, M10 – 70Nm M8- 35Nm
W0001TY158AU-FIT$011005240000*Ä
W0001TY158AU-FIT$011005240000
TOWBAR
For Toyota Avensis Estate 2009-
For use with 3012 series necks
TY158AU-FIT