Electrical Connection; Starting Up; Moving / Placing The Machine - Felker FRS-30 Instructions D'utilisation

4.3 E
LECTRICAL CONNECTION
• ONLY a qualified electrician should con-
nect the machine to the factory electric
power supply per local electrical codes.
• All ground wires must be properly con-
nected.
• Machine MUST be connected to electrical
supply of the same power as the require-
ments indicated on motor ID plate or see 3.1
Technical Data.
The machine is equipped with a 3 meter long Power
Cord and Plug.
In case the machine is placed inside a factory, install a
properly sized magnetic circuit breaker and protect for
the wiring as required by local codes.
When the the machine is used on temporary job sights,
connect the machine to power source outlets with the
plug installed on the machine respecting local safety
regulations.
A
14

5.0 STARTING UP

5.1 M –
OVING PLACING THE MACHINE
• Before moving the machine, disconnect it
from the electrical power supply.
• Always use caution when moving the ma-
chine to prevent damage or personal injury.
Before moving the machine manually:
- Slide the head to the center of Guide Bars, so the
weight is balanced
- Secure the head by tightening the knobs of the 2
limit rings
- Make sure that lever knobs locking the tilting bridge
of the machine are tight.
- Empty the water tank.
- Pull out the lift handles A (Fig. 6) from under the
table and carefully lift to a minimum height to move
the machine.
Two or four men can move the machine (Fig. 6) (de-
pending on the weight).
Fig. 6