Trouble-Shooting; Problems, Causes And Solutions - Felker FRS-30 Instructions D'utilisation

7.1 P ,
ROBLEMS CAUSES AND SOLUTIONS
PROBLEMS
After pushing the START button, the
machine remains off.
The saw motor doesn't rotate.
The saw motor loses power or stalls
while cutting.
The blade motor works but insufficient
or no water flows over the blade.
Material cut is chipped when finished
cutting.

7.0 TROUBLE-SHOOTING

CAUSES
A)No electricity.
B)Electric wire or switch damaged
C)Fuses on electric line are burnt
D)Machine not connected to correct
voltage required.
A)Wrong voltage
B) Bad Motor capacitor.
A)Cutting feed rate is too fast
B)Blade is dull or worn out.
C)Voltage is too low.
A)Water hoses and connections are
dirty.
B)Water hose has kink.
C)Insufficient water level for the
pump.
D)Filter of water pump is dirty
A)Diamond blade out of tension, bent
or using incorrect blade for the ma-
terial.
B)Feed rate too fast at end of cut.
C)Blade not fully penetrating through
the material.
SOLUTIONS
A)Check: electrical connections, cir-
cuit protection device, magnetic
switch inside control box.
B)Repair or replace by qualifiied
electricain
C)Check fuses inside electric box
D)Require assistance.
A)Check electrical connection.
B)Replace by qualified electrician.
A)Reduce cutting speed.
B)Open blade to expose diamonds
or replace blade.
C)Extension cord may be too long.
Or have electric power checked by
qualified electrician.
A)Flush hoses and connection parts
with clear water to clean
B)Straighten or replace hose.
C)Add water to correct level.
D)Clean filter of water pump
A)Replace with new, correct blade
B)Slow the feed rate near end of cut.
C)Increase depth of cut. Blade
should extend about 1/4" beneath
table surface.
19