Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.4 S
E
TANDARD
QUIPMENT AND
O
A
PTION
CCESSORIES
Standard Equipment:
• Open End 30mm Wrench to change the blade
• Rip Fence
• Side Extension Table
Document equipment:
• Instruction manual
3.0 TECHNICAL FEATURES
3.1 T
ECHNICAL DATA
MODEL
Power - HP
Supply voltage - Vac
Supply frequency - Hz
Phase
Full load amps - A
Blade motor - rpm
Blade capacity - in. (mm)
Arbor size - in. (mm)
Length of Cut - in. (mm)
Depth of Cut at 90° - in. (mm)
Depth of Cut at 45° - in. (mm)
Cutting table
L x W - in. (mm)
Side extension
L x W - in. (mm)
Saw dimension w/Leg & extension
L x W x H - in. (mm)
Saw Weight uncrated - lb (kg)
Crated weight - lb (kg)
3.2 N
OISE
Noise produced from the machine on its own is less
than 70dB (A).
General noise level could INCREASE when:
• multiple saws are in the surroundings
• saw is inside of a building
• materials are being cut; some material types produce
more noise than others
• with use of improper acoustic safety devices.
Noise level could DECREASE by:
• reducing the speed rate of cut
• always using blades that are in good condition
• using silent core or Stealth
NOTE:
Acoustic pressure over 85 dB (A) could be dangerous
for your hearing health, it is recommended to always
use an approved hearing safety device while operating
the saw.
FRS 30
FRS 38
1.5
1.5
115
115
60
60
1
1
14.4
14.4
3400
3400
10 (250)
10 (250)
5/8 (15.9)
5/8 (15.9)
30 (750)
38 (950)
2.6 (65)
2.6 (65)
1.2 (30)
1.2 (30)
36.5 x 17.3
44.5 x 17.3
(930 x 440)
(1130 x 440)
12.1 x 11
12.1 x 11
(310 x 280)
(310 x 280)
48.4 x 30.7 x 47.2
56.3 x 30.7 x 47.2
(1230x780x1200)
(1380x780x1200)
145.5 (66)
154.3 ( 70)
170 (77)
181 (82)
L
EVEL
Blades.
TM
FRS 51
2
230
60
1
8.3
1700
14 (350)
1 (25.4)
51 (130)
4.1 (105)
2.4 (60)
60 x 22.5
(1520x 570)
15.7 x 13.8
(400 x 350)
66.9 x 39.4 x 50.8
(1750x1000x1290)
317.2 (144)
350.5 (159)
11
Publicité
Table des Matières
