Start / Stop Operations; How To Use The Machine - Felker FRS-30 Instructions D'utilisation

5.3 S / S
TART TOP OPERATIONS
Your machine is equipped with an electrical control box,
complete with a magnetic ON-OFF switch, composed
of 2 buttons with the following functions (Fig. 8):
(A) RED button: STOP
(B) GREEN button: START
NOTE:
If the electrical power is interrupted, the machine will
remain "OFF" when power is restored until operator
again pushes the START button.
5.4 H
OW TO USE THE MACHINE
• Before starting the machine, be sure that
blade and blade guard are securely tight-
ened.
• Set the machine where nothing danger-
ous is around it that can interfer with cut-
ting operations.
• Connect the machine to a properly protected and
grounded power outlet.
• Before starting the machine, install the drain plug into
the hole located in the bottom ot he water tank. Fill
the tank with clean water until it fully covers the water
pump. Also flush tank and hoses with clean water to
remove debris after cutting each day.
• Place the material to cut against the fence and in line
with cutting plane of the blade.
• Lower/raise the handwheel C (Fig. 9) to adjust cut-
ting height (FRS-51 only).
16
• Never place hands along cutting line of blade
operation.
• To turn on the blade motor and water pump, push
the "green" start button D (Fig. 9). Both the blade
motor and water pump will start.
• Before starting the cutting operations, check for
adequate water flow to the blade. Make adjustment
to flow valve E (Fig. 9) as needed.
The pump MUST ALWAYS work with sufficient water
in the tank (Pump should be fully submerged.) Water
is used to cool the pump and the cutting blade.
B
Without water, both could fail and be permanently
damaged.
A
• Pull handle F (Fig. 9) carefully to advance the cutting
blade to and through the material.
Fig. 8
E
C
D
F
Fig. 9