Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3
A.
Faucet Installation - Center Mount
Remove adhesive backing on trim
A.
ring gasket (1) and press into place
on trim ring (2). Place trim ring on
bottom of spout hub. Insert supply
tubes through mounting hole in sink.
Your faucet is designed for a hole
diameter of 1 3/8" +/- 1/4" (35 mm
+/- 6 mm) and a deck thickness of
up to 3" (76 mm). Maximum deck
thickness of soap dispenser is
3" (76 mm).
77522 Rev. D
2
1
6
B.
2
6
4
5
Push hose (1) partially up into mounting
B.
shank (2). Install the mounting bracket
(3) and nut (4) onto the mounting shank
using wrench (5). For decks up to 1 3/8"
(35 mm) thick use spacer (6) provided
between nut and mounting bracket.
Note 1: The wrench provided is
designed to be used with a variety of
tools: flat/Phillips head screwdrivers,
wrenches, etc. Note 2: For thin gauge
sinks (not recommended), use the
thin deck aid (7) RP49588 as shown
for single and 3 hole installations
to help support the deck. HINT: Turn
the spout tube opposite the handle to
balance the assembly when mounting.
3
7
1
Publicité
Table des Matières
