AKO-Agrartechnik B500 plus Consignes D'utilisation page 5

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 4
Operating Instructions
2
7
8
This energizer shall not be used as an  
animal trainer (inside a barn). 
Ordinary operation with 9V dry battery,
or, optionally the device can be operated
with a 12V – wet accumulator!
a.) Installation
Assemble the earth electrode (7) as shown in the above figure; screw the earth connecting cable (8) onto the earth
electrode with the fastening screw. Drive the earth electrode into the ground as far as the angle brackets and then place
the appliance in upright position in the screwed-on angle brackets, see above figure.
b.) Functional description of the appliance
Open the appliance by pressing the catch hook on both sides and simultaneously raising the lid. Insert the battery into the
receptable and connect to the appliance. Close the lid. Operate the appliance only in vertical position and with the catch
hook clicked firmly into place. Put the appliance into service without fence and earth. If the indicator light flashes, the
appliance is ready for use. If it flashes red, check the 9V battery for correct voltage (min. 6V). If the indicator light does
not flash, check the battery for correct polarity or have the appliance checked by a technician.
c.) Functional description with connected fence system ( fence + earth )
Flashes (3)
green yellow
red
O.K.
YES
-
-
minimum requirement
-
YES
-
see fault finding in enclosed instruction manual
-
-
YES
(Figure 2; p.5)
No pulses
-
-
-
Flashes (2)
9V – battery replace as soon as possible (<6V)
Flashes (2) and (3) not = see b.) Functional description of the appliance, without fence and earth
In switching step 5, the device runs in automatic mode and reduces/increases the output according to the state of the fencing system
(e.g. if the fencing system is in good condition, the device reduces the output and thus saves power = longer running time!)
If the fence light flashes faster than approx. once per second, the appliance must be disconnected at once and checked
by a technician before it can be used again. The device provides 12v operation with total discharge protection. This is
indicated by red blinking of the pilot lamp.
The 12V accumulator voltage should therefore be checked at regular intervals with a highly accurate measuring
instrument (see battery and accumulator maintenance in the enclosed instruction manual). The appliance can also be
operated with a solar kit obtainable through specialised dealers.
Any user of electric fence systems is legally indebted to control the fence-appliance and the fence system regularly, in
accordance with the conditions of use, at least once per day.
-
visual check of the appliance and the fence system
-
measurement of the minimum voltage of 2500V at each point of the fence
This equipment carries a 3-year warranty in accordance with our Warranty Terms & Conditions!
Please see the attached Operating Instructions for safety tips, earthing, commissioning, maintenance of battery
and accumulator, warranty terms and conditions and potential sources of fault!
SERVICE Addresses:
Please contact your specialist dealer
3
1
Output voltage
Rotary switch for power setting
4
1
0 = OFF; 1 = 40%; 2 = 55%; 3 = 75%;
5
4 = 85%; 5 = AUTO (100% capacity)
2 Control lamp 9V battery
3 Control lamp fence
4 Earth connection
6
5 Fence connection
6 Closing buckles
7 Earth rod / holder
Earth connecting cable
8
(Connection between earth connection of
device and earth rod!)
3
-EN-
9V- battery replace
at once
Version : 2019.1

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ba-1158

Table des Matières