brennenstuhl PIR 110 Notice D'utilisation page 13

011409 Bewegungsmelder PIR 110_180_011409 Bewegungsm
PIR 110/180
MOUNTING THE UNIT (see drawing)
Make sure that there is no power flowing
through the power cord. Turn off the power
or remove the corresponding fuse before you
begin any electrical work.
1. Loosen the screw (5) on the mounting plate
(1), remove the sensor housing (3) and re-
move the terminal strip (4) from the hous-
ing.
2. Attach the mounting plate (1) using the wall
screws (2) at the mounting location.
3. Connect the power cord and the light cord as
shown in the drawing in the terminal strip
(4), so that the cord passes through the rub-
ber gasket included and out of the housing.
Fix the power cord in place using a strain re-
lief clamp. Fit the terminal strip back into
place. Mount the sensor housing (3) to the
mounting plate (1) using the mounting plate
screws (5).
After mounting is complete, you can set up the
monitoring area and function status of the mo-
tion sensor.
13