Publicité
Les langues disponibles
Les langues disponibles
GB
5.4
Mounting the transport frame on the
shredder (06)
1. Turn the shredder around.
2. Slide (06/a) the transport frame (06/1) into
the holes of the housing (06/2).
6 START-UP
DANGER! Danger of injury from dam-
aged components! Damaged components can
lead to serious and even fatal injuries!
■
Before putting into operation, carry out a vi-
sual inspection and check the components
for function.
WARNING! Risk of injury due to negli-
gence! Negligence in handling the machine can
result in serious injuries!
■
Only use the shredder on firm, level ground
and in a stable position. Do not tilt or incline
the machine during operation.
■
Comply with working time regulations in force
in your country.
■
Do not route the extension lead over the hop-
per or under the discharge opening.
■
Before starting, ensure that the feed chute is
clear.
7 OPERATION
WARNING! Danger of serious injury!
There is a risk of serious injuries for children, per-
sons with impaired physical, sensory or mental
abilities, persons with insufficient knowledge and
experience and persons who are not familiar with
the operating instructions.
■
Never permit the above persons to use the
machine.
■
Always observe the local regulations con-
cerning the age limit for users.
7.1
Connecting the mains plug
1. Connect the mains cable of the shredder
(01/11) to an extension lead.
2. Check that the extension lead is connected
securely.
3. Then connect the extension lead to the mains
voltage.
22
7.2
Switching on the motor (07)
IMPORTANT! Damage to the machine due
to improper operation! Incorrect handling can
result in machine damage!
■
Only feed in material to be shredded once
the appliance has already been switched on.
■
Do not feed in any further material to be
shredded after the appliance has been
switched off.
1. Press the On switch (07/1).
7.3
Switching off the motor (07)
1. Press the Off switch (07/2).
7.4
Releasing a cutting disk blockage
WARNING! Risk of injury due to lack of
concentration while working! Ejected parts can
cause very severe injuries!
■
Watch out for flying parts and keep your face
away from the feed chute.
CAUTION! Danger of crushing when
opening and closing the housing! Hand and
finger injuries may occur!
■
Beware of your hands and fingers when
opening and closing the housing.
NOTE When closing the housing, ensure
that the top part of the housing is correctly seated
in the cutouts of the lower part.
1. Switch off the shredder.
2. Disconnect the machine from the mains pow-
er supply.
3. Remove (08/a) the locking screw (08/1) and
remove (08/b) the housing (08/2).
4. Remove the material causing the blockage.
5. Check the cutting disk and shredder blade for
damage.
6. Close the housing and tighten the locking
screw again.
7. Reconnect the machine to the mains power
supply.
8. Press the overload protection (07/3).
9. Switch on the shredder again.
If the blockage cannot be cleared, contact our
customer service.
Start-up
MH 2500 Slice
Publicité
