Heath Zenith DUALBRITE SL-4175-SA Mode D'emploi page 6

TESTING
❒ Turn on the circuit breaker and light
switch.
Note: Sensor has a 1
riod before it will detect motion. When
first turned on wait 1
Note: Meets the ENErGY STAr
when D B function is off.
®
UAL rITE
❒ Switch the on-time to TEST position and
D B switch to the OFF position.
®
UAL rITE
TEST 1 5 10 MIN
ON-TIME
Avoid aiming the control at:
• Pools of water or objects that change
temperature rapidly, such as heating vents
and air conditioners. These heat sources
could cause false triggering.
• Areas where pets or traffic may trigger
the control.
• Nearby large, light-colored objects reflect-
ing daylight may trigger the shut-off feature.
Do not point other lights at the sensor.
6 ft.
(1.8 m)
Maximum Range
/ minute warm up pe-
1
2
/ minutes.
1
2
guidelines
®
OFF 3 6 DUSK TO
HOUR DAWN
30 ft.
(9.1m)
Maximum
Coverage Angle
The detector is less sensitive to motion di-
rectly towards it and more sensitive to across
motion.
Motion
Least Sensitive
❒ Walk through the coverage area noting
where you are when the lights turn on.
Move the sensor head left or right to
change the coverage area.
Note: Grasp the sensor
only as shown and turn
the entire sensor. Any
other method may
damage the sensor.
Do not force it past
the stops.
150°
❒ If you need to change the sensitivity,
temporarily remove the fixture and make
the adjustment. Too much sensitivity may
increase false triggering.
❒ Set the amount of TIME you want the
light to stay on after motion is detected.
(1, 5, or 10 minutes).
❒ Set the amount of time after dusk you
want the lights on accent level.
6
Motion
Sensor
Most Sensitive
240°
Sensor Aiming
Adjustment Angle
595-5578-09