MINN KOTA MKA-4 Mode D'emploi page 3

2
ITEM(S) NEEDED
d. Secure the Support Shaft to the Bow-mount with
the 1/4" Hex Head Screw (Item #2) and Lock
Washers (Item #4). The Hex Head Screw should
pass through a Lock Washer, then the Upper Arm of
the Bow Mount, then another Lock Washer and into
the Support Shaft.
e. Attach the Rubber Bumper (Item #8) to the bottom
of the Support Shaft where it contacts the Boat
Deck or Gunwale.
f. Verify that the motor locks into the stowed position
when retracted. The Stabilizer should support the
Bow-mount to prevent bouncing yet not interfere
with the locking system. Adjust the Support Shaft
length as needed.
Complete Typical Installation
For warranty information, please visit
minnkotamotors.com
Part #2264990
#2 x 1 #4 x 2
minnkotamotors.com.
Minn Kota Consumer & Technical Service
Johnson Outdoors Marine Electronics, Inc.
PO Box 8129
Mankato, MN 56001
#8 x 1
2d
2f
Mount Mount
121 Power Drive
Mankato, MN 56001
Phone (800) 227-6433
Fax (800) 527-4464
ECN 40110
Hex Head Screw Hex Head Screw
Lock Washer Lock Washer
Screw Hole Screw Hole
Lock Washer Lock Washer
Support Shaft Support Shaft
Rubber Bumper Rubber Bumper
Upper Arm Upper Arm
Support Support
Shaft Shaft
©2020 Johnson Outdoors Marine Electronics, Inc.
All rights reserved.
Rev D 09/20