Weston 07-1201-W Mode D'emploi page 6

ASSEMBLY INSTRUCTIONS
1. Apply a few drops of vegetable oil to the
rubber Drive Shaft O-Ring (3).
2. Ensure the Drive Shaft Clip (4) and Drive
Shaft O-Ring seal (3) are in place on the
drive shaft. NOTE: This configuration is
pre-assembled on first use (5). FIGURE A
3. Insert the Screen Gasket (18) into the
large end of the Screen (15), making sure
the Gasket is under the Thumbscrew (11).
FIGURE B
4. Slide the red plastic Spiral (9) onto the
Drive Shaft (5) over the Spring (14). Be
sure to match the flats on the Drive Shaft
to the metal insert in the side of the Spiral.
FIGURE C
5. Align the notches of the Body (2) with
the notches in the Multi-Purpose Screen
(15). FIGURE D
6. Holding the Body firmly in one hand,
push the Multi-Purpose Screen (15) over
the Spiral (9) and Drive Shaft Assembly
(5) and compress, then turn 1/8th of a
turn counter-clockwise to lock it in place.
(NOTE: The "ON" - "OFF" direction arrows
are on the base of the Multi-Purpose
Screen.)
7. Tighten the Screen Thumbscrew (11)
to lock the Screen in place (NOTE: Finger
tighten only, do not over tighten). FIGURE
E
NOTE: Operating the Tomato Press
& Sauce Maker while empty is NOT
recommended. The juice from the fruits
and vegetables act as a lubricant for the
mechanisms and reduce wear on the
components.
6
4
5
3
18
15
5
9
14
2
FIGURE A
14
11
FIGURE B
FIGURE C
FIGURE D
15
11
FIGURE E