Description Of The Product; Technical Data - V2 NYK-24V Mode D'emploi

EU DECLARATION OF CONFORMITY
AND DECLARATION OF
INCORPORATION OF PARTLY
COMPLETED MACHINE
Declaration in accordance with Directives: 2014/35/UE (LVD);
2014/30/UE (EMC); 2006/42/CE (MD) ANNEX II, PART B
The manufacturer V2 S.p.A., headquarters in Corso Principi di
Piemonte 65, 12035, Racconigi (CN), Italy
Under its sole responsibility hereby declares that:
the partly completed machinery model(s): NYK-24V
Description: electromechanical actuator for gates
• is intended to be installed on gates, to create a machine
according to the provisions of the Directive 2006/42/EC.
The machinery must not be put into service until the final
machinery into which it has to be incorporated has been
declared in conformity with the provisions of the Directive
2006/42/EC and 89/106/CE.
• is compliant with the applicable essential safety requirements
of the following Directives:
Machinery Directive 2006/42/EC (annex I, chapter 1)
Low Voltage Directive 2014/35/EU
Electromagnetic Compatibility Directive 2014/30/EU
Directive ROHS2 2011/65/CE
The relevant technical documentation is available at the national
authorities' request after justifiable request to: V2 S.p.A., Corso
Principi di Piemonte 65, 12035, Racconigi (CN), Italia
The person empowered to draw up the declaration and to provide
the technical documentation:
Sergio Biancheri
Legal representative of V2 S.p.A.
Racconigi 01/06/2019

TECHNICAL DATA

Max. leaf lenght
Max. leaf weight
Power supply
Idling current
Full load current
Electric power
Opening time of the leaf 0÷90°
Max travel
Operating speed
Maximum thrust
Working temperature
Protection
Working cycle
Motor weight

DESCRIPTION OF THE PRODUCT

This product has been designed to automate gates or doors with
leaf opening, for residential or industrial use.
m
Any other use different to that described and in ambient
conditions different to those set out in this manual is to be
considered improper and forbidden!
The product is an electromechanical gear motor, equipped with
a 24V continuous current alternate current motor and an endless
screw reduction gear.
The gear motor is powered by the external control unit to which it
is connected.
In the event of a black out, it is possible to move the gate leaves
by hand, unblocking the gear motor manually.
NYK-24V
m 2
Kg 250
24Vdc
A 0,4
A 6
W 80
s 16
mm 320
m/s 0,013 ÷ 0,016
N 1500
°C -20 ÷ +55
IP 44
% 50
Kg 6
- 10 -
CAUTION!