Grohe Tectron 37 321 Manuel D'installation page 7

GB
Safety notes
• Installation is only possible in frost-free rooms.
• The control electronics are only suitable for indoor use.
• Use only genuine replacement parts and accessories.
The use of other parts will result in voiding of the warranty
and the CE identification.
Technical data
• Flow pressure:
- min.
- recommended
• Operating pressure:
• Test pressure:
• Temperature:
• Voltage supply:
(transformer 230 V AC/12 V AC)
• Power consumption:
(Standby power consuption < 1 VA)
• Flow volume (1 - 7 l adjustable):
• Minimum delay (2 - 10 s adjustable):
• Type of protection:
• Pipe:
• Integrated isolating valve
Electrical test data
• Software class
• Contamination class
• Rated surge voltage
• Temperature for ball impact test
The test for electromagnetic compatibility
(interference emission test) was performed
at the rated voltage and rated current.
Programme 1 functions (factory setting)
• Cleaning mode:
• Automatic flushing (24h):
• Detection zone according to Kodak Gray Card,
grey side, 8x10", landscape:
• Pre-flushing:
• Intermediate flushing:
Further pre-set programmes can be selected via the sensor
system, see the programme table on page 6.
Special accessories
Further settings and special functions are available via
the infrared remote control (Prod. no. 36 206).
Approval and conformity
This product conforms to the requirements of the
relevant EU directives.
The conformity declarations can be obtained from the following
address:
GROHE Deutschland Vertriebs GmbH
Zur Porta 9
D-32457 Porta Westfalica
Final installation
, see fold-out page II, Figs. [1] - [7].
Operation
The infrared electronics emits invisible pulsed light. If this light
is reflected by a user for a minimum of 7 seconds (minimum
delay) and is then received again by the electronics, the bowl
is flushed after the user moves away.
The detection zone is dependent upon the reflective properties
of the object.
Activating cleaning mode
• Only possible when temporary shutoff is activated.
• The detection zone must kept clear.
0.05 MPa 1. Hold finger against the lower area of the sensor system,
0.1 - 0.5 MPa
max. 1 MPa
1.6 MPa
max. 45 °C
█████████████████████ ██ ██ ██ ██ ██
230 V AC
2. Remove finger from the sensor system while
1.8 VA
Cleaning mode is active for 3 minutes. The indicator lamp
2 l
7 s
IP 55
Terminating cleaning mode prematurely
DN 15
1. Hold finger against the lower area of the sensor system,
A
2
█████████████████████____
2500 V
2. Remove finger from the sensor system while
100 °C
Making settings
Setting mode
activatable
Setting mode has the following functions:
activated
- Changing the flow volume
- Querying and changing the programme
45cm
- Checking the detection zone
deactivated
The indicator lamp in the sensor system illuminates in setting
activated
mode when the detection zone of the fitting is reached by an
approaching user. Flushing is immediately triggered when the
detection zone is exited again. The minimum delay is not
available in setting mode.
see Fig. [8].
Indicator lamp signals:
██ ██ ██
is displayed.
flashes during this time.
see Fig. [8].
Indicator lamp signals:
displayed.
Cleaning mode is terminated.
is
____
4