Valor H6 Serie Instructions D'installation page 3

Installation at time of framing
1. On the top of the appliance's case in front of the
stand-offs, remove the positioning brackets (2
screws each); they are not used with this kit.
2. Fit the upper panel support to the top of the
appliance's case as indicated (5 screws).
3. Install the lower panel using the three studs at the
base of the appliance (3 nuts).
4. On the appliance, install the side panels as
indicated (3 screws per side).
5. Assemble the heatshield to the upper panel as
indicated (5 screws).
6. Install the upper panel as indicated (3 screws).
3