Disposal Of The Product - NORAUTO 2223561 Mode D'emploi

Note
1. Please pay attention to the difference on the size of the driller for camera and the sensors.
2. When install the system, the car should be in powered off situation.
3. The performance may be affected in the following situation: heavy rain; the gravel road, bumpy road,
sloping road and bush; very hot, cold or moist weather, the sensors is covered by snow, ice mud,
etc.
4. Other ultrasonic or electric wave, the instance of DC/AC switch or 24/12V switch maybe affect the
performance of the system.
5. The sensor should not be installed too tightly or too loose.
6. The metal bumper maybe affect the performance of the system.
7. Don't locate the control unit near to other interference such as exhaust pipe or other wires.
8. Test the system to make sure it work well before using.
9. This system is a reversing aid and the manufacturer takes no responsibility for any accidents caused
after the kit is installed.

Disposal of the product

This marking indicates that this product should not be disposed of with other household
wastes throughout EU. To prevent possible harm to the environment or human health from
uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of
material resources. To return your used device, please use the return and collection systems
or contact the retailer where the product ws purchased.They can take this product for
environmentally safe recycling. Separate collection of used products and packaging allows materials
to be recycled and used again. Re-use of recycled materials helps prevent environmental pollution
and reduces the demand for raw materials. Local regulations may provide for separate collection
of electrical products from the household, at municipal waste sites or by the retailer from whom you
purchased a new product.
32