Kärcher MIC 34C Mode D'emploi page 49

 When attaching the chassis mounted spreader to the
vehicle for the first time, the left and right front guide
must be adjusted.
1 Screw (one visible, two covered)
2 Guidance
 Adjust guide: Loosen 3 screws at the front side by ap-
prox. 1 rotation (left and right).
 Slide the chassis mounted spreader all the way to the
front until the safety bolts in the back can be locked.
 Tighten the visible screw.
 Unlock the safety bolts and slide the chassis mounted
spreader slightly to the back, tighten the remaining
screws.
 Slide the chassis mounted spreader all the way to the
front and lock it with safety bolts in the back.
1 Hydraulic couplings main PTO
2 Electric connectors
 Connect the hydraulic hoses and electrical plug with
the respective couplings.
8.8.2 Operations
 Switch on the PTO to switch on the control
8.8.3 Connecting the work light
 Plug the plug of the lamp into the socket at the hind car-
riage.
 Switch on the working light with the switch.
8.9 Balance weight without
attachment hitch
2
1
1 Safety pin
2 Counterweight
 Unlock the safety bolt by turning it and pull it out toward
the side.
 Slide the counter weight into the square pipes of the
machine frame.
 Slide in the safety bolt and lock it by turning it.
8.10 Balance weight with
attachment hitch
1
2
1 Safety pin
2 Counterweight
3 Towing hitch
 Unlock the safety bolt by turning it and pull it out toward
the side.
 Slide the counter weight with the attachment hitch into
the square pipes of the appliance frame.
 Slide in the safety bolt and lock it by turning it.
17
-
EN
1
1
3
49