MANGA STREET SCOOP Montage page 9

PI
SEAT
JOINING
Place a washer and nut loosely on joining bracket's threaded rod.
5
Insert the joining bracket in the 22 mm hole and make sure that it goes
through and opens on the inside of Scoopi a. Screw the threaded rod in
so about ca 45-50 mm (1,77 in) is protruding. Screw the washer and nut
tight. Repeat for second hole. For indoor use mount felt shoes like shown
on page 4 no 1 and return to this page afterwards.
2 x JOINING BRACKETS
M 8 mm
20 mm
4 x WASHERS 40 mm
4 x NUTS M 8 mm
a
45 mm thread
1,77 in thread
Manga Street does not guarantee
against theft or vandalism.
Place Scoopi a and b close together so the two linking brackets go through the
6
two pre-drilled holes on Scoopi b. Fit the washer and nut on both joining brack-
ets through the large hole in Scoopi b and tighten it so that the two Scoopis are
securely attached together. Repeat on the other Scoopis in the layout. See page 4
for filling in sand and mounting the large plug. For mounting Scoopi Button, see
page 7.
a
a
a
a + b
SCOoPI´s with sand and joined.
EN
b
6-12