MANGA STREET SCOOP Montage page 6

PI
SEAT
ASSEMPLY
FILLED with SAND or MOUNTED to the ground?
1
MOUNTED to the ground - hard surface - outside:
2
(See page 10 for bracket for EPDM rubber
button and EPDM table.)
MANGA STREET APS
Web: www.mangastreet.eu
Mail: manga@mangastreet.eu
BRACKET for
PE plastic button
Place the Scoopi bracket like shown in no 2. Fasten with washers and
3
bolts so it is quite firm. Mount brackets on all Scoopis in the layout.
For inspiration see page 1.
2 x BOLTS
M 10 mm x 20 mm
2 x WASHER
2 x SPRING WASHER
Place the Scoopi in the desired lay-
4
out. Here is a layout with 6 Scoop-
is. Mark in holes of the bracket.
Remove Scoopi. Drill holes in the
ground. Place Scoopi again and
mount one at a time to the ground
with expansion bolts or what is
suitable for a hard surface.
Place large plug in the hole
inside Scoopi. Mount Scoopi
Button like shown on page 7.
3-12