Scoopi & Scoop Care - MANGA STREET SCOOP Montage

PI
SEAT
SCOOP & SCOoPI
Scoop & Scoopi Seat are not attached together. But placed quite
close together. If you choose to fix them in a permanent position,
use the F2 brackets for Scoop and one of the two variations of
brackets for Scoopi.
You can also pour sand in the Scoopi instead see both variations on
page 3-4.
NOTE! The Scoopi Button in rubber must always be mounted on
the bracket's threaded rod regardless of whether the Scoopi stands
outside or inside/is fixed in a permanent position or not.
F2 SCOOP BRACKET
Important: Plug in the bottom of Scoop: Remove before permanently
fixing the Scoop in position. To mount the Scoop, see its instructions.
SCOoPI with SAND
SCOoPI BRACKET
for PE plastic button
SCOoPI with bracket
Manga Street does not guarantee
against theft or vandalism.
SCOoPI & SCOOP CARE
Scoop & Scoopi and Scoopi Button in plastic, require very little maintenance.
If necessary, clean them with soap and water or/and with "rubber and plastic
cleaner" on any blemishes. They can easily be cleaned with a pressure washer.
Scoopi Button made from rubber, as well as Scoopi Table and Scoopi Table
Top, also in rubber, are water permeable and durable. Rubber products can be
cleaned and the colours can be freshened up with a shampoo that is suitable
for cleaning rubber.
Rubber products can be cleaned with a pressure washer, but carefully and with
less pressure so the surface is not damaged or becomes frayed. Chewing gum
can often be removed using the above method, or you can also use a freeze
spray. Then remove it mechanically. If lights are fitted in Scoop Light, the light
chain, etc., must not be cleaned with water. See Scoop assembly instructions
for cleaning and mounting this.
EN
10-12