MANGA STREET SCOOP Montage page 11

PI
TABLE
MOUNTING - SCOoPI Table
Drill with an 18 mm drill bit in the two holes in the front of the Scoopi as
1
shown in the drawing below on both a and b.
18 mm
2 Position both Scoopi brackets and mount them as shown on page 3.
Insert the Scoopi Table's threaded rods into the pre-drilled holes and
mount with the 16 mm nuts supplied through the large hole on the inside
of the Scoopi in both a and b.
a
a + b
b
4 x NUTS M 16 mm
Manga Street does not guarantee
against theft or vandalism.
Place the Scoopi/Scoopis in the desired layout, where the two
3
Scoopis a + b are fitted with a Scoopi Table.
c
a
b
See pages 3-4 for fixing it to a firm surface or filling it with sand and
how to mount the large plug.
See pages 7 and 10 for mounting the Scoopi Button.
EN
d
8-12