Publicité
Les langues disponibles
Les langues disponibles
Assemble the top
1
The table top (1) is shipped with the combination miter-gauge track/
T-track (2) in place, but fastened only with a plastic rivet. Remove
the rivet and secure the track with the system screws (3), driving them
into the holes in the table top.
2
Turn the table top upside down. Align the two support struts (4) with
holes in the bottom of the table top. Drive ¾" coarse-thread screws
(5) with the driver bit (6).
ATTENTION
In this step, use the ¾" screws (5), NOT the 1¼"
screws (8).
3
Position an insert-plate leveler (7) in each corner of the table-top
opening. The holes in the levelers align with holes in the table-top.
Fasten the levelers to the tabletop with 1¼" coarse-thread screws (8).
4
Using the hex wrench (9), drive a set screw (10) into the outside
holes in each leveler, threading them in from the bottom until the
tips are ⅜" below the table surface.
Assembly
1
2
5
8
7
10
9
5
3
4
Publicité
