ShelterLogic SuperMax 26764 Guide D'assemblage page 8

9. TIGHTEN THE COVER
A. Use 4 Ratchets (10040) to tighten down the corners
of the cover.
Adjust the cover so there is equal overhang on all
sides.
While the ratchet is in the closed position, thread the
cover's webbing through the ratchet as shown.
B. Insert "S" hook into the hole in the leg that is about
/
1
9 inches down the leg pole.
2
Tighten the ratchets equally, alternating from one
corner to another until the cover is tight.
10. POSITION YOUR CANOPY FOR ANCHORING
A. Position your canopy so that the 4 corners are within 1 to 2 inches
from the measurements taken in Step 1 (next to the spikes).
B. At one leg at a time, remove each spike and move the foot to the
location the spike was removed from.
C. Insert the spike through one of the holes in the base foot into the
ground at an angle until the round head is touching the base foot.
D. Repeat this at each of the 4 corners. Use the remaining spikes in
each middle foot.
NOTE:
Spike Anchors are for positioning of the unit
ONLY and are not intended for permanent anchoring.
Page 8
A
/
1
9 in.
2
10431
05_26764_D1
B