ShelterLogic SuperMax 26764 Guide D'assemblage page 4

1. PlOT THE lOCATION
Before building your canopy, choose a flat area and plot your location.
A. With enclosed Spikes (10431), stake out the area for the canopy in the desired spot.
The width (W) of the area should be at least equal to the width of the canopy (18 FT.)
and the length should be at least equal to the length (L) - 40 FT.
B. To be sure the staked area is square, tie a rope diagonally from corner to corner.
C. Measure from where the two ropes intersect each other to all 4 corners. These
measurements (A and B) should be the same. If they are not equal the spikes need to
be adjusted until the width, length and inside measurements are correct.
2. lAY OUT ROOF FRAME
• Assembly is easiest if you lay out the roof parts as shown in the location you intend to erect the shelter.
• Start by assembling the center peak then assemble each side.
• All connections will use 2
802083
802105
803111
802105
802084
803111
802105
802084
803111
802105
802084
803111
802105
802084
803111
802105
802084
803111
802105
802083
/
1
inch (# 10017) bolts, EXCEPT where noted (
2
802081
802104 802104
803111
802082
802104 802104
803111
802082
802104 802104
803111
802082
802104 802104
803111
802082
802104 802104
803111
802082
802104 802104
803111
802104 802081 802104
802083
802105
803111
802105 802084
803111
802105
802084
803111
802105
802084
803111
802105
802084
803111
802105
802084
803111
802105
802083
Page 4
18 ft. W
A B
) use 2 inch (# 10114) bolts.
NOTE:
Install all
carriage bolts with the
nut toward the center
of the frame.
05_26764_D1
40 ft. L