Product Disposal - UFESA PV0500 Mode D'emploi

TROUBLESHOOTING
Problem
Soleplate is not heating even
though iron is turned on.
Iron does not produce steam
Steam jet and vertical steam jet
function does not work
The iron leaking
White streaks come through the
holes in the soleplate

PRODUCT DISPOSAL

This product complies with European Directive 2012/19/EU on electrical and electronic
devices, known as WEEE (Waste Electrical and Electronic Equipment), provides the legal
framework applicable in the European Union for the disposal and reuse of waste electronic
and electrical devices. Do not dispose of this product in the bin, instead going to the electrical
and electronic waste collection centre closest to your home.
We hope that you will be satisfied with this product.
Possible cause
Connection problem
Temperature control is in MIN
position
Not enough water in tank
Steam control is selected in
non-steam position.
Selected temperature is lower than
that specified to use with steam.
Steam jet function was used very
frequently within a short period.
Iron is not hot enough
The temperature setting is too low
to produce steam.
The soleplate has a build-up of
scale because it has not been
self-cleaned regularly.
Solution
check main power supply
cable,plug and outlet.
select adequate temperature
Fill water tank
Set steam control between
positions of minimum steam and
maximum steam (see "iron chart").
Select a higher temperature
Put iron on horizontal position and
wait before using steam jet function.
Adjust to higher temperature to
steam ironing.Put iron in vertical
position and wait temperature
indicator light becomes fixed.
The variable steam knob must be
set on"0"position until the iron is
hot.
Do the self-cleaning process.
Remember to do it at least every
two weeks.
17