Montage - Endress+Hauser iTEMP PCP DIN rail TMT121 Manuel D'instructions

Table des Matières

Publicité

TMT121
;

Montage

Zulässige Umgebungstemperatur:
-40 bis 85 °C (für Ex-Bereich siehe Ex-Zertifikate)
Einbauort: Montage auf Hutschiene nach IEC 60715 TH35,
z. B. im Schaltschrank
Einbaulage: keine Einschränkungen
"
Achtung!
Sicherheitshinweis: Das Gerät darf nur von einem Netzteil mit
energiebegrenzten Stromkreis nach IEC 61010-1 gespeist wer-
den: 'SELV oder Class 2 circuit'
<
Installation
Ambient temperature:
-40 to 85 °C (-40 to 185 °F). For Ex-area see Ex-Certification
Installation area: Installation on DIN rail according to IEC 60715
TH35, e.g. in control panel
Installation angle: No limit
"
Caution!
Safety instructions: The unit must only be powered by a power
supply that operates using an IEC 61010-1 compliant energy
limited circuit: 'SELV or Class 2 circuit'
2
=
Montage
Température ambiante :
-40 à 85 °C (pour zone Ex, voir certificat Ex)
Position de montage : Montage sur rail profilé selon IEC 60715
TH35, par ex. en armoire électrique
Implantation : Pas de restriction
"
Attention !
Conseils de sécurité : L'appareil doit obligatoirement être ali-
menté par une alimentation stabilisée selon IEC61010-1 : 'SELV
ou Class 2 circuit'.
Endress+Hauser

Publicité

Table des Matières
loading

Table des Matières