Power Cord; Parts Identification - Power Fist 8458804 Manuel D'utilisateur

V 3.0

POWER CORD

1. Insert the power cord plug directly to the power supply. Do not use extension cords or surge protectors.
2. Do not operate this tool if the power cord is frayed or damaged as an electric shock may occur, resulting in
personal injury or property damage.
a. Inspect the tool's power cord for cracks, fraying or other faults in the insulation or plug before each use.
b. Discontinue use if a power cord feels more than comfortably warm while operating the tool.
c. Have the power cord replaced by a qualified service technician
3. Keep all connections dry and off the ground to reduce the risk of electric shock. Do not touch plug
with wet hands.
4. Prevent damage to the power cord by observing the following:
a. Never use the cord to carry the tool.
b. Do not pull on the cord to disconnect the plug from an outlet.
c. Keep the power cord clear of the tool and the tool's work path while in operation. The cord should always
stay behind the tool.
d. Keep cord away from heat, oil, sharp edges or moving parts.
e. Do not allow people, mobile equipment or vehicles to pass over unprotected power cords.
i. Position power cords away from traffic areas.
ii. Place cords in reinforced conduits.
iii. Place planks on either side of the power cord to create a protective trench.
USE AND CARE OF TOOL
1. Use the correct tool for the job. This tool was designed for a specific function. Do not modify or alter this
tool or use it for an unintended purpose.
2. Do not carry the tool with fingers near or on the trigger/switch.
3. Avoid unintentional starts. Be sure that the ignition switch/trigger is in the neutral or OFF position when not
in use or before connecting it to any power source.

PARTS IDENTIFICATION

Remove the parts and accessories from the packaging and inspect for damage. Make sure that all items in the parts
list are included.
WARNING! Do not operate the tool if any part is missing. Replace the missing part before operating. Failure to
do so could result in a malfunction and personal injury.
Contents:
1. Water outlet
2. Power cord
3. Motor and pump (inside case)
4. Handle
5. Hose connector (to spray gun)
6. Hose connector (to water outlet)
7. High-pressure hose
8. Nozzle-cleaning needle
9. Trigger lock
10. Spray gun
11. Adjustable spray wand
4
1.6 GPM @ 1,740 PSI Electric Pressure Washer 8458804
For technical questions call 1-800-665-8685
FIG. 1