Power Fist 8458804 Manuel D'utilisateur page 9

8458804
Problem(s)
Spray wand or extension
or nozzle leaks
Pump makes
excessive noise
Water leaks from pump
(up to 3 drops per minute
is normal)
Oil drip
Motor buzzes but
fails to run
Visit www.princessauto.com for more information
1.6 GPM @ 1,740 PSI Electric Pressure Washer
Possible cause(s)
Spray wand not properly attached
Broken o-ring or plastic insert
Pump is sucking air
Loose fittings
Water seals are damaged or worn
Oil seals are damaged or worn
Supply voltage below minimum
System has residual pressure
Voltage loss due to extension cord
Pressure washer not used
for long periods
Suggested solution(s)
Remove spray wand and reattach according to
Assembly instructions
Bring to Princess Auto Ltd. or a
qualified technician
Ensure hose and fittings are airtight. Turn off
unit and purge pump by squeezing trigger until
a steady flow of water emerges through
the nozzle.
Tighten fittings
Bring to Princess Auto Ltd. or a
qualified technician
Bring to Princess Auto Ltd. or a
qualified technician
Verify that only the pressure washer is running
on this circuit
Turn unit off, squeeze trigger on spray wand to
release pressure, then turn unit on
Do not use extension cord with this unit. Plug
directly into power outlet.
Bring to Princess Auto Ltd. or a
qualified technician
V 3.0
9