Assembling; Rating Plate; Operation And Handing - CASO DESIGN FW 2000 Black Mode D'emploi

16.2 Assembling

a) Place the motor unit (1) on a table.
The locking handle (3) at tube inlet (4)
has to be in horizontal position. Place
the head tube (7) into the tube inlet
(4).
b) Turn the locking handle (3) in vertical
position.
c) Place the snake (8) with the thicker
end first into the head tube (7).
d) Place the blade (9) on the snake (8).
tigthe it with your hand.
g) Place the hopper plate (6) as seen on
illustration on the head tube (7).
Do not block the air passage at the bottom.

16.3 Rating plate

The rating plate with the connection and performance data can be
founded beneath the device.

17 Operation and Handing

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
► Do not leave the device unsupervised when it is in operation, so that you can intervene
quickly in the event of dangers.
► Cool the head tube (7) vor using oft he device in the refrigerator or rinse it with cold
water, this will improve the processing.
e) Place the
cutting plate (10, 11
or 15) on blade (9)
and snake (8)
f) Place the
fixing ring (12) and
Warning
Please note
33