Skil 6443 Consignes De Fonctionnement/Sécurité page 7

SM 2610993480 7/00 8/3/00 12:40 PM
TRIGGER CONTROLLED VARIABLE SPEED
Your tool is equipped with a variable speed
trigger switch. The tool speed can be
controlled from minimum to maximum
nameplate rated RPM by the pressure you
apply to the trigger. Apply more pressure to
increase the speed and release pressure to
decrease speed (Fig. 1).
"LOCK-ON" BUTTON
The "Lock-ON" button, located in the handle
of your tool allows for continuous operation at
maximum RPM without holding the trigger.
TO LOCK TRIGGER "ON": squeeze trigger,
depress button and release trigger.
TO UNLOCK THE TRIGGER: squeeze trigger
and release it without depressing the "Lock-
ON" button.
If the "Lock-ON" button is
WARNING
!
continuously being depressed,
the trigger can not be released.
FORWARD/REVERSING LEVER &
TRIGGER LOCK
Your tool is equipped with a forward/reversing
lever and trigger lock located above the trigger
(Fig. 1). This lever was designed for changing
rotation of the chuck, and for locking the
trigger in an"OFF" position to help prevent
accidental starts. For forward rotation, (with
the chuck pointed away from you) move lever
to the far left. For reverse rotation move the
lever to the far right. To activate trigger lock
move lever to the center off position.
INSERTING BIT
For small bits, open jaws enough to insert the
bit up to the flutes. For large bits, insert the bit
as far as it will go. Center the bit as you close
the jaws by hand. This positions the bit
properly, giving maximum contact between
the chuck jaws and the bit shank.
KEYED MODELS
To tighten chuck, insert key into each of the
three key holes in succession and tighten
firmly. The chuck can be released by using one
hole only (Fig. 3).
KEYLESS MODELS
To tighten, hold the chuck collar firmly with
one hand and securely tighten the chuck
sleeve with the other hand (Fig. 4).
Page 7
Operating Instructions
CAUTION
!
to a complete stop. Shifting during rotation of
the chuck can cause damage to the tool.
PRESET SPEED ADJUSTING DIAL
This feature enables you to preset the trigger
at desired speeds by rotating the dial on the
trigger to a higher or lower setting. Regardless
of the pressure applied on the trigger, the tool
will not operate any faster than maximum
speed setting selected.
MODE SELECTOR SWITCH
The mode selector switch allows the tool to
be set for various drilling applications. Slide
the switch right or left depending on the
below applications (Fig. 2).
Drill only action: For drilling in woods, metals,
plastics or other non concrete materials.
Drill with hammer action: For drilling in
concrete, asphalt, tile or other similar hard
materials.
FIG. 2
WARNING
!
loosen or tighten the chuck by using the power
of the drill.
FIG. 3
FIG. 4
-7-
Do not change direction of
rotation until the tool comes
To prevent friction burns, or
possible hand injury, do not
Counter
Clockwise
Clockwise
CHUCK CHUCK
COLLAR SLEEVE