Wahl 73535 Mode D'emploi page 2

RECHARGING
1. Remove the clipper, recharging transformer and accessories from the packing material.
2. Before the appliance is used for the first time, it should be charged for 3 to 5 hours. It then takes 3 to 5 hours to fully recharge the battery again. The
appliance is charged by plugging directly into the appliance. During charging, the charging indicator is illuminated. The charging indicator will begin to flicker
when almost fully charged and may shut off when fully charged.
3. Plug the recharging transformer into any convenient electrical outlet at the correct voltage. If clipper is on, turn to off position when charging.
4. When clipper is not in use, it may be connected to the transformer and plugged into an outlet to assure maximum power is available when it is next used. This
transformer is designed to charge the battery without overcharging.
TROUBLESHOOTING
If your clipper does not seem to take a charge, check the following before returning it for repair:
1. Check outlet operation by plugging in another appliance.
2. Make sure the outlet is not connected to a switch which turns the power at the outlet off.
3. Be sure the clipper is properly connected to the recharging transformer, all connections are secure and the switch on the clipper is turned "OFF - 0."
4. If your electricity is connected to a master power switch, we suggest the clipper be disconnected from the charger anytime the master switch is off. Leaving the
unit plugged into a dead outlet or an unplugged charger will drain the battery.
5. If clipper does not run and it is completely charged, turn the unit "ON - I" and pinch or push the blades manually. (Oil may have dried out between the blades,
so they may be temporarily stuck together.)
INSTRUCTIONS FOR THE USE AND CARE OF WAHL CLIP-
RECHARGEABLE OPERATION
CLIPPER USE AND MAINTENANCE
1. A fully charged Lithium Ion clipper can deliver up to 90 minutes of continuous use.
2. When clipper is not in use, it should be connected to the transformer to assure maximum power whenever it is used. The transformer is designed to
charge the battery, without overcharging.
3. It is normal for the unit to become somewhat warm during normal use.
4. Avoid pressing the blades strongly against the skin, being especially careful around the ears. (The blades should be directed toward the skin at a right
angle, but without significant pressure.)
5. After cutting damp hair, clean and oil the blades before storing the unit. Place a small drop of WAHL CLIPPER OIL ONLY on the ends of the blades
then move the switch to the "1" (ON) position.
6. To clean the unit, use either a clean, dry or dampened cloth. DO NOT USE benzine or thinner to clean the unit.
7. Do not store the clipper in a wet or moist environment.
8. To prolong blade life, do not use clipper on hair that is coated with a permanent wave solution or hair spray.
9. Do not touch any of the internal mechanisms.
OIL
The blades of your new clipper should be oiled every few haircuts. Simply place a few drops of Wahl Clipper Oil on the teeth of the blades.
Use only the Wahl Clipper Oil included in the pack. Due to the high speed of your Wahl clipper, the correct type of oil must be used. Do
not use hair oil, grease or any oil mixed with kerosene or any solvent, as the solvent will evaporate and leave the thick oil, slowing down the
blades. Wahl Clipper Oil is a very thin, natural oil which will not evaporate and will not slow down the blades.
CORD CARE
The cord should not be used to pull the clipper. Since freedom of movement needs to be maintained, care should be used to keep the
cord untwisted and unobstructed. When stored, the cord should be coiled and the unit placed in original box or storage pouch (if provided), away from
children.
LITHIUM-ION BATTERY DISPOSAL
Do not attempt to remove the battery from unit. Lithium-Ion batteries can explode, catch fire, and/or cause burns if disassembled, damaged, or exposed
to water or high temperatures. Do not attempt to remove the battery for disposal. Lithium-Ion batteries may be subject to local disposal regulations.
Many locations prohibit disposal in standard waste receptacles. Check your local laws and regulations. For recycling contact a government recycling
agency, waste disposal service, retailer, or visit online recycling sources, such as www.batteryrecycling.com or www.rbrc.org.
WAHL'S GUIDE TO FOOLPROOF ANIMAL CLIPPING
Assemble your supplies:
Clipper, oil, blades, slicker brush, attachment combs and comb, scissors, tear-free shampoo, dryer, rubber bath mat, nail cutters. Be sure all your equipment is in
good working condition and easy to reach. Grooming should be done on a solid table (about 30" high) with a non-slip surface to give your dog a steady and secure
footing. A grooming post to secure the dog would be of considerable aid. Good lighting is essential. The light should be adequately bright and evenly distributed;
there should be no shadows.
BEFORE YOU CUT
Brush out coat thoroughly
a) Remove all snarls, knots, tangles and mats.
SAVE THESE INSTRUCTIONS
This Clipper Has Been Designed For Household Use Only
PERS